Wheel Head : it is of rigid construction and holds the spindle assembly. It can be flitted horizontally and swiveled vertically full 360 degree, for quick setting of compound angles. Wheel head is mounted on the rigid column, which can be raised/lower up/down. Wheel head also can be adjusted 150mm on cross direction.
Wheel Head Spindle: Alloy steel hardened and ground spindle is mounted on precision pre-loaded radial ball bearings, which are greased packed. The grinding wheels can be mounted on both sides of the spindle and the wheels mount design is such that the spindle can be reversed.

Work Table : This is mounted on the carriage and can be swiveled 45 degree on either side of the column. This table has a smooth and rapid movement longitudinally on the carriage through a roller chain guided and Supported on jibs. Slow movement is through a reduction gearbox. Change over from rapid to slow movement is through a push/pull knob. The precise movement on roller chain enables smooth, sensitive and accurate longitudinal movement even with heavy jobs. The adjustable reversing dogs on the worktable are spring loaded for shockproof reversal of table. Auxiliary Table: This table is mounted on worktable and can be fine adjusted 9 degree on either side. It carries the work head & tail stock, between which jobs are mounted.

Universal Work Head : This can be swiveled full 360 degree in both Horizontal and Vertical planes. It can hold job up to 600mm with the aid if raising blocks. It’s spindle nose has ISO 50/MT 5 tapes and the spindle is mounted to taper roller bearings.